Sullair ES-6 series - Page 4

TABLE OF CONTENTS
34 3.10 IDENTIFICATION, ES-6 ENCLOSED TANK MOUNT (80 GALLONS)
WITH DRYER
36 3.11 IDENTIFICATION, ES-6 OPEN TANK MOUNT (120 GALLON)
38 3.12 IDENTIFICATION, ES-6 ENCLOSED TANK MOUNT (120 GALLON)
40 3.13 IDENTIFICATION, ES-6 OPEN TANK MOUNT (120 GALLON) WITH
DRYER
42 3.14 IDENTIFICATION, ES-6 ENCLOSED TANK MOUNT (120 GALLON)
WITH DRYER
44 3.15 PIPING AND INSTRUMENTATION DIAGRAM—STANDARD AND WYE-
DELTA
46 3.16 WIRING DIAGRAM—DUAL CONTROL FULL VOLTAGE 2-WIRE
48 3.17 WIRING DIAGRAM—DUAL CONTROL FULL VOLTAGE 3-WIRE
50 3.18 WIRING DIAGRAM—DUAL CONTROL 200-230/1/60 5 HP
52 3.19 WIRING DIAGRAM—DUAL CONTROL WYE-DELTA
54 3.20 WIRING DIAGRAM—SRS 25-100 115-230V/1/60
56 3.21 WIRING DIAGRAM—SRS 9-18 220-240V/1/50
58 3.22 WIRING DIAGRAM—SRS 24-30 220-240V/1/50
SECTION 4—INSTALLATION
61 4.1 LOCATION OF COMPRESSOR
61 4.2 VENTILATION AND COOLING
61 4.3 SERVICE AIR PIPING
61 4.4 FLUID LEVEL CHECK AND CHANGE PROCEDURE
62 4.5 MOTOR ROTATION DIRECTION CHECK
62 4.6 ELECTRICAL PREPARATION
SECTION 5—OPERATION
65 5.1 GENERAL
65 5.2 PURPOSE OF CONTROLS
66 5.3 INITIAL START-UP PROCEDURE
66 5.4 SUBSEQUENT START-UP PROCEDURE
66 5.5 SHUTDOWN PROCEDURE
SECTION 6—MAINTENANCE
67 6.1 GENERAL
67 6.2 DAILY OPERATION
67 6.3 MOTOR BEARING LUBRICANT
68 6.4 FLUID FILTER MAINTENANCE
68 6.5 COOLER MAINTENANCE
69 6.6 PARTS REPLACEMENT AND ADJUSTMENT PROCEDURES
75 6.7 TROUBLESHOOTING
75 6.8 TROUBLESHOOTING GUIDE
77 6.9 MAINTENANCE RECORD