TABLE OF CONTENTS
Section 5
OPERATION 15 5.1 GENERAL
15 5.2 PURPOSE OF CONTROLS
15 5.3 INITIAL START-UP PROCEDURE
Section 6
MAINTENANCE 17 6.1 GENERAL
17 6.2 DAILY OPERATION
17 6.3 MOTOR BEARING LUBRICATION
17 6.4 FLUID FILTER MAINTENANCE
17 6.5 COOLER MAINTENANCE
18 6.6 PARTS REPLACEMENT AND ADJUSTMENT
PROCEDURES
18 FLUID FILTER REPLACEMENT
18 AIR FILTER MAINTENANCE
18 SEPARATOR ELEMENT REPLACEMENT
19 MINIMUM PRESSURE/CHECK VALVE
MAINTENANCE
20 THERMOSTAT ACTUATOR MAINTENANCE
20 CONTROL SYSTEM ADJUSTMENT
21 INLET CONTROL VALVE
22 MOTOR SHAFT SEAL REPLACEMENT
22 6.7 TROUBLESHOOTING
TROUBLESHOOTING GUIDE
25 6.8 MAINTENANCE RECORD
Section 7
ILLUSTRATIONS AND
27 7.1 PROCEDURE FOR ORDERING PARTS
PARTS LIST 27 7.2 RECOMMENDED SPARE PARTS LIST
28 7.3 FLUID MANAGEMENT SYSTEM
30 7.4 SEAL AND DRIVE GEAR
32 7.5 MOTOR, HOUSING AND PARTS
34 7.6 COMPRESSOR COOLER SYSTEM
36 7.7 COMPRESSOR SYSTEM
40 7.8 INLET FILTER AND INLET CONTROL
42 7.9 CONTROL BOX
44 7.10 DECAL GROUP
48 7.11 DECAL LOCATIONS
50 7.12 WIRING DIAGRAM
To Next Page
Loading...
