Section 3
SPECIFICATIONS
7
3.1 TABLE OF SPECIFICATIONS
DIMENSIONS (IV)
(50 Hz)
MODEL KW COOLING CAPACITY LENGTH WIDTH HEIGHT (V) WEIGHT (VI)
(M
3
/MIN) (MM) (MM) (MM) (KG)
100--H
(ENCL.)
(I)
75 AIR 13.45 2398 1219 1886 1483
100--H
(W/O ENCL.)
(I)
75 AIR 13.45 2002 1219 1525 1197
100--H
(ENCL.)
(I)
75 WATER 13.45 2398 1219 1886 1483
100--H
(W/O ENCL.)
(I)
75 WATER 13.45 2002 1219 1525 1197
(60 Hz)
(III)
MODEL HP COOLING CAPACITY LENGTH WIDTH HEIGHT (V) WEIGHT (VI)
(ACFM) (IN) (IN) (IN) (LB)
100--L
(ENCL.)
(II)
100 AIR 500 94 48 74 1/4 3270
100--L
(W/O ENCL.)
(II)
100 AIR 500 79 48 60 2640
100--L
(ENCL.)
(II)
100 WA TER 500 94 48 74 1/4 3270
100--L
(W/O ENCL.)
(II)
100 WATER 500 79 48 60 2640
100--H
(ENCL.)
(I)
100 AIR 460 94 48 74 1/4 3270
100--H
(W/O ENCL.)
(I)
100 WATER 460 79 48 60 2640
100--H
(ENCL.)
(I)
100 AIR 460 94 48 74 1/4 3270
100--H
(W/O ENCL.)
(I)
100 WATER 460 79 48 60 2640
(I)
Model H Maximum Pressure: 125 psig/8.6 bar
(II)
Model L Maximum Pressure: 110 psig/7.6 bar
(III)
Includes standard and 24KT. New series pressure range designations appearing after model number are as follows:
“L” -- 7.0 to 7.5 bar “H” -- 8.0 to 8.5 bar .
(IV)
The minimum distance that the compressor should be from surrounding walls and ceilings is 3 ft/915 mm, and preferably 6 ft/1829 mm
or more from the fan air discharge end of the compressor.
(V)
The minimum height allowance needed to service the separator elements is 6 ft, 3 in/1905 mm.
(VI)
Weight includes enclosure.
NOTE: dBA RATI NG S FREE FIELD NOISE LEVELS: 75 dBA ( ENCLO SED), 85 dBA (OPEN).
COMPRESSOR:
T ype: Positive displacement, fluid--lubricated, twin
rotary screws
Configuration: Single--stage geared integral drive
Bearing T ype: Anti--friction
Lubricant: Pressurized Sullube 32
Coolant : S ee S ec t ions 3. 2 and 3. 3 on Lubr ic at ion
Sump Capacity: 9 gallons (34 liters)
(Continued on page 8)
To Next Page
Loading...
