Section 9
ILLUSTRATIONS AND PARTS LIST
69
9.12 COMPRESSOR DISCHARGE SYSTEM (WATER--COOLED)
key part
number description number quantity
1 tank, air fluid sep 14” 02250054--125 1
2 hose, corrugated st stl 3” 02250059--184 1
3 flange, threaded 2 1/2” 819315--040 1
4 silencer, air 1/2” 041006 1
5 valve, blowdown 2--way pneu
(I)
250030--276 1
6 orifice, 1/2”m x 1/2”f .156 234125--156 1
7 support, sep/trap combo 02250053--355 1
8 sep/trap, combination
(II)
410143 1
9 probe, rtd 100ohm 250039--909 2
10 tubing, stl steel 1/4” 841215--004 15 ft.
11 valve, 2” npt min press check 242405 1
12 u--bolt 6” 829008--600 3
13 separator, air/fluid prim
(III)
02250060--462 1
14 o--ring, 3 3/4” x 1/8” 826502--240 1
15 gasket, asa 2 1/2” 150# 240621--7 1
16 separator, air/fluid second
(III)
02250060--463 1
17 valve, relief 500cfm 02250055--464 1
18 valve, ball 3/8” 047116 1
19 tubing, thermoplastic 3/8” od 250024--746 4
20 support, bracket aftclr ls--20 02250061--876 2
21 support, bracket water in/out cust con 02250061--758 1
22 heat exchanger , aftercooler 043008 1
23 cross, pipe 150# 2” 801315--080 1
24 nipple, pipe 2” x 2 1/2” sc 40 822132--025 1
25 plug, pipe 1/2” steel 807800--020 1
26 connector, tube m 1/4” x 1/4” 810204--025 4
27 bushing, red 2” x 1/2” 150# 802108--020 1
28 capscr, hex gr5 5/8”--11 x 2 3/4” 828610--275 4
29 capscrew, hx gr 5 3/8” x 1 1/4” 828606--125 4
30 nut, hex 3/8” 824206--337 4
31 washer, lock reg 3/8” 837506--094 4
(Continued on page 71)
(I)
For maintenance on blowdown valve no. 250030--276, order repair kit no. 02250045--132.
(II)
For maintenance on separator/trap no. 410143, order repair kit no. 250033--038.
(III)
For separator maintenance, order replacement element kits no. 02250061--137 (primary), and no.
02250061--138 (secondary).
PLEASE NOTE: WHEN ORDERING PARTS, INDICATE SERIAL NUMBER OF COMPRESSOR
To Next Page
Loading...
