SECTION 4 E-680 CONTROLLER FOR REFRIGERANT DRYERS
165
3. 3. Channel Offset
4. 4. Channel Offset
5. 5. Channel Offset
6. 6. Channel Offset
7. 7. Channel Offset
8. 8. Channel Offset
9. 1. Channel Input Type
10. 2. Channel Input Type
11. 3. Channel Input Type
12. 4. Channel Input Type
13. 5. Channel Input Type
14. 6. Channel Input Type
15. 7. Channel Input Type
16. 8. Channel Input Type
2.3.6. C
ALIBRATION PAGE
1. 50mV Cal (Channel 1)
2. 0°C Cal. (Channel 1)
3. Ambient Temp. Cal. (Channel 1)
4. 1. RT Cal. (390 ohm)
5. 2. RT Cal. (390 ohm)
6. 3. RT Cal. (390 ohm)
7. 4. RT Cal. (390 ohm)
8. 5. RT Cal. (390 ohm)
9. 6. RT Cal. (390 ohm)
10. 7. RT Cal. (390 ohm)
11. 8. RT Cal. (390 ohm)
The 7th and 8th Parameters in the “Time Parameters
Page” (Filter Change Period and Maintenance
Period) and all the parameters in “Calibration Page”
can not be edited unless the Digital Input 10 is
activated (Configuration Enable).
While ‘Filter Change Period’ parameter is selected,
pressing the buttons and simultaneously, resets the
FILTER TIME to 0.0.
While ‘Maintenance Period’ parameter is selected,
pressing the buttons and simultaneously, resets the
RUN TIME to 0.0.
To Next Page
Loading...