To Next PageTo Next Page
Need help?Do you have a question about the Sullair RH-0035-115-60-A and is the answer not in the manual?
General| Model | RH-0035-115-60-A |
|---|---|
| Category | Dryer |
| Type | Refrigerated |
| Capacity | 35 SCFM |
| Voltage | 115 V |
| Phase | Single |
| Frequency | 60 Hz |
| Inlet Temperature | 100°F |
| Ambient Temperature | 100°F |
| Maximum Pressure | 232 psi |
| Dew Point | 38°F |
Provides essential safety guidelines for operating and maintaining the dryer.
Illustrates a standard installation setup for the RH Series dryers without after-coolers.
Outlines crucial safety notes, transportation, installation, and operating precautions.
Provides step-by-step instructions for starting and shutting down the dryer.
Electrical wiring schematics for the RH Series dryers.
Details the operating parameters and conditions for the RN & RD Series dryers.
Outlines safety regulations, issues to avoid, and inspection/transportation guidelines.
Explains the functioning of the refrigerant circuit and compressed air heat exchanger.
Advises verifying parameters, checking integrity, and ensuring qualified personnel for startup.
Outlines pre-operation checks including manual review, safety, and pipe size verification.
Provides a sequence of operations for initial startup, shutdown, and regular use.
Details the sequential steps for safely starting and shutting down the dryer unit.
Electrical wiring schematic for RN5-10-15-20-25 models.
Electrical wiring schematic for RN30-50-75-100 models.
Electrical wiring schematic for RN125-150 models.
Electrical wiring schematic for RN175 models.
Electrical wiring schematic for RN200 models.
Electrical wiring schematic for RN250-325 models.
Electrical wiring schematic for RN250-325 (230V) models.
Electrical wiring schematic for RN250-325 (230V) models.
Electrical wiring schematic for RN250-325 (460V/400V) models.
Electrical wiring schematic for RN250-325 (460V/400V) models.
Provides detailed maintenance procedures for technicians and users, including recommended schedules.
Guides users through identifying and resolving common dryer problems and fault conditions.
Describes the E-680 controller's design, features, and capabilities for refrigerant dryers.
Details the front panel view, buttons, display, and basic operating modes of the controller.
Guides through entering configuration mode, security codes, and parameter setup pages.
Electrical wiring schematic for RD400 (230V) models.
Electrical wiring schematic for RD400 (230V) models.
Electrical wiring schematic for RD400 (460V/400V) models.
Electrical wiring schematic for RD400 (460V/400V) models.
Electrical wiring schematic for RD500/700 (230V) models.
Electrical wiring schematic for RD500/700 (230V) models.
Electrical wiring schematic for RD 500-6000 (460V/400V) models.
Electrical wiring schematic for RD 500-6000 (460V/400V) models.
Electrical wiring schematic for RD700-850 (230V) models.
Electrical wiring schematic for RD700-850 (230V) models.
