INSTALLATION, START-UP & MAINTENANCE MANUAL
SD-220 TO SD-600
REV 04 – 10 Oct 2003
Page 6 of 32
CAUTION!
• Never make structural changes to the adsorption dryer!
• Only use original Sullair spares and accessory parts!
• Never weld on a pressure vessel or change it in any way!
• Carry out maintenance work only when the adsorption dryer is
switched off, is depressurized and disconnected from the electric
power supply.
☛ Note
Refer to the desiccant material safety data sheet (MSDS) when installing or
disposing of desiccant.
DANGER!
Wear protective goggles when working with the desiccant!
☛ Note
• If desiccant comes into contact with the eyes, rinse eyes immediately with
a large amount of clear water.
• If the desiccant is spilled, clean up without causing swirls of dust.
• In case of fire, there is no restriction on the use of fire extinguishing
material; the reaction with water and foam is defined as strong.
• A mask must be worn to avoid inhalation of the desiccant dust.
1.3. PERSONNEL QUALIFICATION
The personnel involved in operation, maintenance, inspection and assembly must have the
corresponding qualifications to do this work. Areas of responsibility and supervision of the
personnel must be precisely established by the operator. Should the personnel not
possess the necessary knowledge, then they must be trained and instructed. If need be,
this training may be carried out by the manufacturer / supplier at the request of the
operator of the adsorption dryer. Further, the operator is to make sure that the personnel
completely understand the contents of the technical manual.
To Next Page
Loading...
Need help?
General
