INSTALLATION, START-UP & MAINTENANCE MANUAL
SD-220 TO SD-600
REV 04 – 10 Oct 2003
Page 4 of 32
SECTION 1: INTRODUCTION
1.1. GENERAL INFORMATION
The adsorption dryer of the SD-220 to SD-600 series is built according to the latest
technological developments and recognized safety rules. Its use however can endanger
life and limb of the user or of third parties, and can lead to considerable damage to the
adsorption dryer and other material assets if:
• it is operated by personnel not trained or instructed in its use,
• it is improperly used,
• it is improperly maintained or serviced.
This can result in the loss of all damage claims.
This adsorption dryer is designed for neutral media free of aggressive water, oil and solid
elements. Sullair
accepts no liability for corrosion damage and malfunctions caused by
aggressive media.
Applications other than those mentioned in this manual must be agreed to by Sullair and
confirmed in writing.
In the interest of further development, Sullair
reserves the right to make changes at any
time, which, in keeping with the essential characteristics of the adsorption dryer described
here, may be necessary for increasing efficiency or for reasons relating to safety or to
normal business practice.
1.2. SAFETY INSTRUCTIONS
This technical manual contains basic tips, which must be followed during set-up, operation
and servicing. It is thus of utmost importance that it is read by the assembly technician
before installation and start-up as well as by the specialist or operator in charge, and it
must always be within reach at the location where the adsorption dryer is being used.
To Next Page
Loading...
Need help?
General
