Sullair SD-600 - Page 3

INSTALLATION, START-UP & MAINTENANCE MANUAL
MODEL NO.: SD-220 TO SD-600- DDS OPTION
REV 0 – May 24,,.2001
3
SECTION 5 DRYER FLOW CAPACITY AND PURGE ADJUSTMENT.......................... 27
5.1 DRYER FLOW CAPACITY............................................................................................ 27
5.2 CORRECTION FACTOR FOR INLET TEMPERATURE............................................. 27
5.3 PURGE ADJUSTMENT.................................................................................................. 28
SECTION 6 SPARE PARTS LIST......................................................................................... 29
6.1 SPARE PARTS LIST FOR SD-220 TO SD-400 ............................................................. 29
6.1 SPARE PARTS LIST FOR SD-500 TO SD-600 ............................................................. 30
6.2 INLET-EXHAUST VALVE MANIFOLD....................................................................... 31
6.2 OUTLET-CHECK VALVE MANIFOLD........................................................................ 32
SECTION 7 TROUBLE SHOOTING & FAULTS................................................................. 33
7.1 THE DEW POINT IS TOO HIGH ................................................................................... 33
7.2 THE ADSORPTION DRYER DOES NOT SWITCH OVER......................................... 33
7.3 BACK PRESSURE IS TOO HIGH DURING REGENERATION PHASE.................... 34
7.4 SHORT-TERM SHUT-DOWN........................................................................................ 34
7.5 SHUT-DOWN IN CASE OF A FAULT OR FOR MAINTENANCE............................. 35
7.6 RE-STARTING ................................................................................................................ 35
SECTION 8 ANNEX................................................................................................................... 1