Sullair V-200TS - Page 4

TABLE OF CONTENTS
Section 4
OPERATION 27 4.3 MOTOR ROTATION DIRECTION CHECK
(CONTINUED) 27 4.4 FAN MOTOR ROTATION CHECK
Section 5
SUPERVISOR CONTROLLER™
28 Figure 5-1 Supervisor Controller™ Panel
Section 6
MAINTENANCE 29 6.1 SPIRIAL VALVE REGULATOR
Section 7
ILLUSTRATIONS ANDPARTS LIST
31 7.1 PROCEDURE FOR ORDERING PARTS
31 7.2 RECOMMENDED SPARE PARTS LIST
32 7.3 MOTOR, COMPRESSOR AND FRAME -
VSD IN STARTER BOX
34 7.4 MOTOR, COMPRESSOR AND FRAME-
EXTERNAL VSD
36 7.5 VSD MOUNTING
38 7.6 AIR INLET 100-150HP/75-112KW
40 7.7 AIR INLET 200-250HP/150-187KW
42 7.8 AIR PIPING- AIR-COOLED
46 7.9 AIR PIPING- WATER-COOLED (100HP/75KW ONLY)
50 7.10 AIR PIPING- WATER-COOLED (125-150HP/93-112KW ONLY)
54 7.11 AIR PIPING- WATER-COOLED (200HP/93-150KW ONLY)
58 7.12 PNEUMATIC CONTROLS
60 7.13 STARTER ASSEMBLY WITH VSD IN STARTER BOX
64 7.14 STARTER ASSEMBLY WITH EXTERNAL VSD
68 7.15 ENCLOSURE- AIR-COOLED
70 7.16 ENCLOSURE- WATER-COOLED
72 7.17 DECAL GROUP
80 7.18 DECAL LOCATIONS- AIR-COOLED OPEN
(VSD Inside Electrical Enclosure)
82 7.19 DECAL LOCATIONS- AIR-COOLED OPEN
(VSD Outside Electrical Enclosure)
84 7.20 DECAL LOCATIONS- WATER-COOLED OPEN
(VSD Inside Electrical Enclosure)
Continued ...