Section 10
ILLUSTRATIONS AND PARTS LIST
101
10.18 ELECTRICAL CONTROLS- V-200S
key part
number description number quantity
1 starter, man mtr prot ab (I) -1
2 fuse, kldr (I) -2
3 fuse, limitron ktk-r (I) -1
4 cutler hammer vsd (I) -1
5 transformer, control univ.volt(fused) (I) -1
6 transformer, control univ.volt (cb) (I) -1
7 contactor, ac 3p 120v chf (I) -1
8 breaker, circtl high inrush (I) -3
9 adapter, expand 1/8-27f x 1/8-27m 879302-002 2
10 elbow, tube 90 deg m 1/4 x 1/4 ss 877004-025 1
11 elbow, tube 90 deg m 1/4 x 1/8 ss 877004-012 1
12 bushing, red pltd 1/4 x 1/8 867100-005 2
13 bulkhead, pipe 1/8” npt 841500-002 2
14 tubing, stnls stl 1/4” 20ga 841215-004 1
15 washer, spr lock-metric pltd m4 838804-090 8
16 washer, pl-b reg pltd 3/8 838206-071 4
17 washer, spr lock reg pltd 3/8 837806-094 4
18 capscr, hex gr5 3/8-16 x 1 3/4 829106-175 4
19 nut, hex metric m4 x .7 825904-070 8
20 nut, hex pltd 3/8-16 825206-337 4
21 nut, wing pltd #10-24 824815-002 36
22 adapter, female pipe 1/2 x 1/4 811504-025 3
23 plug, hole n4 1/2” cond 409918-002 4
24 plug, straight thread 3/4-16 viton 250042-623 1
25 probe, rtd 100 ohm plat 3.5”x 12ft 250039-909 3
26 fitting, compress adj 250028-635 2
27 block, contact 1nc 250027-125 1
28 contact, aux 1 no 250023-370 1
29 connector, straight 1/4t pls 1/8 npt f 250021-379 1
30 elbow, 90 1/4”tube x 1/8”npt 250018-429 2
31 switch, pressure n.o. 10 psi 250017-992 1
(I) This part may vary per machine design. Consult factory with machine serial number to determine the
proper part number.
PLEASE NOTE: WHEN ORDERING PARTS, INDICATE SERIAL NUMBER OF COMPRESSOR
Continued on page 103
To Next Page
Loading...
