EasyManua.ls Logo

Sulzer Piranha S10 - User Manual

Sulzer Piranha S10
20 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
www.sulzer.com
Submersible Grinder Pump Type ABS Piranha S10 - PE125
6006085 (08.12.2020)
en
Installation, Operating and Maintenance Instructions

Table of Contents

Questions and Answers

  • C
    catherinesheltonAug 12, 2025
    What to do if my Sulzer Piranha S10 does not run?
    • M
      Maria WeissAug 12, 2025
      If your Sulzer Water Pump isn't running, several factors could be at play. It might be due to a moisture sensor shutdown, which means you should check for loose or damaged oil plugs, or replace a faulty mechanical seal or damaged o-rings. Another reason could be an air lock in the volute; try shaking or raising and lowering the pump repeatedly until air bubbles no longer appear. Also, examine the level control to ensure the float switch isn't faulty or tangled. Check for any jammed objects in the impeller and remove them, adjusting the gap if necessary. Finally, ensure the gate valve is open and that the non-return valve isn't blocked.
  • B
    brownkatrinaAug 19, 2025
    Why is my Sulzer Water Pump making excessive noise or vibration?
    • J
      Jose ScottAug 19, 2025
      Excessive noise or vibration in your Sulzer Water Pump can stem from a few key issues. A defective bearing could be the culprit, requiring a replacement. Alternatively, the impeller might be clogged; in this case, remove and clean the hydraulics. Lastly, check the rotation direction; if it's wrong, interchange two phases of the power supply cable to correct it.
  • T
    teresawardAug 26, 2025
    What to do if my Sulzer Water Pump is switching on/off intermittently?
    • K
      Kathleen LeachAug 26, 2025
      If your Sulzer Water Pump is switching on and off intermittently, it could be due to a temperature sensor shutdown; the motor will restart automatically once the pump cools down. Another potential cause is the thermal relay settings in the control panel, so check those. Also, inspect the impeller for any blockages. If none of these solutions work, a service inspection is required.
  • C
    Craig StewartSep 3, 2025
    Why does my Sulzer Water Pump have low head or flow?
    • T
      Tyler WareSep 3, 2025
      If your Sulzer Water Pump has low head or flow, it could be due to the wrong direction of rotation; change the rotation by interchanging two phases of the power supply cable. Another cause might be a gap that is too wide between the impeller and the bottom plate; reduce this gap. Also, ensure the gate valve is fully open.

Sulzer Piranha S10 Specifications

General IconGeneral
BrandSulzer
ModelPiranha S10
CategoryWater Pump
LanguageEnglish

Related product manuals