Need help?Do you have a question about the Sulzer XFP-PE5 and is the answer not in the manual?
General| Installation | Submersible |
|---|---|
| Frequency | 50 Hz |
| Protection class | IP68 |
| Application | drainage |
| Max. head | 22 m |
| Impeller type | Vortex |
| Voltage | 400 V |
Describes the purpose of gaps in explosion-proof motors and safety regulations.
Outlines examination, reporting, and nameplate requirements for motor repairs.
Provides advice on dismantling, examination, and assembly of Ex motors.
Details the examination of flame paths and castings for damage.
Details critical dimensions, gaps, and surface finish for Ex motors.
Steps to remove the connection chamber assembly.
Steps to install the connection chamber assembly.
Procedures for dismantling and assembling cables.
Steps to remove the upper bearing assembly.
Steps to install the upper bearing assembly.
Procedures for draining coolant and removing the cooling jacket.
Steps to remove motor housing and shaft unit.
Procedures for seals, covers, and lower bearings.
Steps to remove motor housing and shaft unit.
Procedures for seals, covers, and lower bearings.
Procedures for hydraulics, coolant release, and chamber removal.
Procedures for mechanical seals and motor housing.
Steps for shaft unit and lower bearings.
Procedures for hydraulic and motor unit dismantling/assembly.
Steps for removing and installing the impeller.
Procedures for bottom plate removal, assembly, and gap adjustment.
Procedures for hydraulic and motor unit dismantling/assembly.
Steps for removing and installing the impeller.
Procedures for changing the volute wear ring.
Optional service for impeller wear ring.
Procedures for hydraulic and motor unit dismantling/assembly.
Steps for removing and installing the impeller.
Procedures for shroud removal, assembly, and gap adjustment.
To Next Page
