18 Cyclo® BBB4 Quick Start Guide
Top View
4
Confirm that the rubber bushings can still be rotated by hand. This
indicates the bushing has not been over-tightened.
Compressed bushings will not allow the bushings to properly absorb
the loads of the shaft mounted gearbox. This can lead to premature
failure.
Mounting angle bracket must be secured to the machine
structure.
5
Confirm the mounting angle bracket does not interfere with the
torque arm. There should be no metal-to-metal contact between
the two during a complete revolution of the driven equipment.
Metal-to-Metal contact between these two components
may lead to catastrophic failure of the reducer/ gearmotor.
Bushing are
free to rotate by
hand
To Next Page
