OPERATION
Starting
Close the circuit breaker by pushing up the handle.
Press the power switch.
The indicator in the switch will light. The compressor will start. Any items drawing power from
the compressor will start.
PREVENT EQUIPMENT DAMAGE. After starting the system for the first time,
to be certain that the water lines are properly connected, check that the outlet
water temperature is warmer than the inlet water.
Stopping
At the compressor, press the power switch.
The indicator light in the switch will go off. The compressor will stop. Any items drawing power
from the compressor will stop.
Restarting After a Power Failure
If the compressor stops due to a power interruption, it is designed to restart immediately after
the power has been restored. If the compressor stops for other reasons, compressor
troubleshooting is required.
To Next Page
Loading...
