8
3 Receiving
3 Receiving
Please perform the following tasks after receiving the CC-Link Option:
• Inspect the CC-Link Option for damage.
• Verify receipt of the correct model by checking the information on the nameplate (see Figure 2).
• If you have received the wrong model or the CC-Link Option does not function properly, contact your supplier.
◆ Contents and Packaging
Table 1 Contents of Package
◆ Tool Requirements
Note: Tools required to prepare CC-Link cables for wiring are not listed in this manual.
Description: Option unit Ground Cables Warning Label Stickers Installation Manual
–
Quantity: 1411
A Phillips screwdriver (M3, M3.5 to M5 <1>) metric or (#1, #2 <1>) U.S. standard size is required to install the CC-Link Option.
<1> Screw sizes vary by drive capacity. Select a screwdriver that matches the drive capacity.
To Next Page
Loading...
