Sumitomo SH145X-6

To Next Page

To Previous Page

CONFIDENTIAL:FORTHEINTERNAL

USEOFTUTTBRYANTEQUIPMENT

Contents

Main Page

Table of Contents3
1-General Information9
Safety Rules and Warnings Definitions9
Additional Information9
To All Users10
About the Front, Rear, Left, and Right of this Machine12
For Safe Operation12
Explanation of Main Parts15
2-Safety Information17
Safety Rules17
After Work Is Completed31
Safety Decals45
27. Avoid Getting Knocked over59
37. Anti-Interference Emergency Release Switch62
3-Description of Handling65
Entering and Leaving the Cab65
Cab Door65
Entering and Leaving the Machine66
Positions of Control Sections and Accessories Within Cab68
Operator's Seat70
Suspension Seat Adjustment70
Armrest Angle Adjustment Section73
Swing/Attachment Operation75
Hand Control Levers and Pedals75
Anti-Interference System (Offset Boom Type)82
Anti-Interference Override Switch82
Handling of Anti-Interference System (KHP25790)84
Actuation of Anti-Interference System (Offset Boom Type)85
Actuation of Anti-Interference System85
Cautions for Handling Anti-Interference System (Offset Boom Type)86
Windshield88
Front Lower Window89
Front Right Console90
System Display and Function Control Panel91
Monitor Switch97
Menu Screen Display102
Left-Hand Side Controls111
Left Side Console111
Air Conditioner Control113
Air Flow113
Air Circulation114
Air Flow Direction114
Air Conditioner115
Auto115
Gate Lock Lever (Safety Bar)117
Cab Interior Lightning118
Emergency Exit Hammer118
Opening and Closing the Windows on Doors118
Right Side Control119
Right-Hand Console119
Right Console121
Coat Hanger Hook122
Drink Holder122
Radio123
Automatic Station Selection (Seek)125
Auto Preset125
Aux125
Rearward Controls128
Overhead Controls129
Outside Control130
4-Operation Explanations145
Cautions for Operating this Machine145
Handling a New Machine145
Cautions for Using a New Machine145
Start-Up Inspections (Inspections before Starting Work)146
How to Perform Start-Up Inspections146
Anti-Theft150
Anti-Theft Function150
Anti-Theft Function Setting150
How to Use Anti-Theft Function151
Starting and Stopping the Engine153
Before Starting the Engine153
Battery153
Basic Operations before Starting the Engine153
Starting the Engine154
Basic Operations for Starting the Engine154
Inspection after Starting the Engine155
Stopping the Engine (Normal)156
Warm-Up Operation158
Anti-Interference System Start-Up Inspection (Offset Boom Type)161
Travel Operation162
Starting out162
Travel Alarm163
Stopping164
Travel Levers165
Travel Speed Selection167
Cautions When Traveling167
Cautions for Traveling Uphill and Downhill (Slopes)168
Escaping from Weak Ground169
Cautions for Use in Permitted Water Depth and on Weak Ground169
Towing the Machine171
Swing Operation172
Swing Operation Procedure172
Attachment Operations174
Machine Operations175
Phenomena Unique to Hydraulic Excavator175
Cautions When Operating175
Cautions against Interference176
Special Attachments177
Option Hydraulic Circuits (Option)177
Hydraulic Breaker or Crusher Hydraulic Circuit (Option)177
Multi-Purpose Circuit with Pressure Adjuster (Option)181
Option Hydraulic Circuit Flow Patterns184
Stop Valves (Optional)185
Safety Valves (Optional)185
Service Specifications185
On Boom Cylinder185
On Arm Cylinder185
Cautions When Operating Machine186
Cautions for Operations186
Cautions for Working on an Incline186
Travel with the Bucket Dug into the Ground Prohibited186
Pounding the Bucket to Force It into the Ground Prohibited186
Caution for Working at End of the Hydraulic Cylinder Stroke187
Using the Swinging Force to Do the Work Prohibited187
Machine Operation Procedure188
Digging188
Loading188
Backfilling189
Boom Operation189
Excavating189
Bucket Inversion and Replacement190
When Work Is Completed191
Parking the Machine191
Inspection after Work192
Cold Weather Arrangements193
Cold Weather193
Fuel and Lubricants193
Battery193
Mixing Anti-Freeze193
When the Cold-Weather Season Is over194
Handling under Special Conditions195
Operating in Cold Weather (When the Outside Air Temperature Is 0℃ or Lower)195
Operating in Severe Heat (When the Outside Air Temperature Is 35℃ or Higher)195
Operating in Dusty and Sandy Locations195
Operating in Coastal Areas195
Operating in High Humidity and on Soft Ground196
Operating with a Danger of Falling Rocks196
Long-Term Storage197
Before Storage197
During Storage197
After Storage (When Using Again)198
5-Transporting this Machine199
Cautions When Loading and Unloading199
Switch Settings for Loading and Unloading199
Caution During Transport200
Loading and Unloading200
Cautions for Transporting Position (with Long Arm Attached)203
Fixing203
Fixing - Supporting at Four Points204
Lifting the Machine208
General Information211
General Cautions for Service211
Service Chart214
Hydraulic Fluids, Fuels, and Lubricants219
Hydraulic Oil Capacities and Lubricant Specifications226
Genuine Sumitomo Product226
Consumable Parts227
Important Safety-Related Parts Requiring Periodic Replacement228
Lubrication and Element230
Retightening Bolts, Nuts, and Hose Fittings234
Start-Up Inspection239
Grease Points243
Level251
Engine253
Cooling System256
Fuel System259
Releasing Pressure in the Hydraulic System268
Hydraulic Circuit269
Air Filter277
Swing Reduction Gear280
Travel Reduction Gears282
Shoes283
Shoe Roller and Take-Up Roller285
Radiator and Coolers285
Fan Belt and Alternator Belt287
Adjustment of Engine Valve Rocker Clearances288
Fuel Tank Filter288
Fire Extinguisher (Not Supplied)288
Electrical/Electronic System Protection During Charging and Welding288
Cab Protection (ROPS and FOPS)290
Machine Inspection and Cleaning291
Checking the Machine Settings291
Plastic and Resin Parts291
Checking Cylinders for Leaks292
Tooth Tip Wear Limits on the Backhoe Bucket293
Replacing Bucket Teeth: Standard Type (Length Pin Type)293
Adjustment of Bucket Backlash295
Replacing a Backhoe Bucket297
Air Conditioning298
Gas Spring Inspection301
Fuse302
Battery Disconnect Switch305
Batteries306
Alternator309
Starter Motor309
Replacing the Light Bulb310
Trouble Notification312
7-Troubleshooting313
Engine-Related314
Monitor Display316
Operation317
Hydraulic Pump317
Machine318
Travel318
Swing319
Hydraulic Cylinder319
8-Specification321
Main Specifications321
Dimension322
Bucket and Arm Types333
Shoe Type334
Function335
9-Options337
Breaker337
Breaker Handling (Attachment)337
Cautions for Using Hydraulic Breaker338
Crusher340
Crusher Handling (Attachment)340
Special Attachments342
Operation Pedal Position343
Handling of Pedal343
Operation of Proportional Switch344
Breaker Operation345
Fuel Tank Feed Pump346
Fuel Tank Feed Pump (if Equipped)346
Load Handling348
Load Handling Eye349
10-Index351

Sumitomo SH145X-6 - Page 8

Table of Contents