Summit Professional VC28S Wine Cooler light not working, how to fix?
If the light in your Summit Professional Wine Cooler does not work, please check: * Ensure the appliance is connected to a power supply. * Check for a tripped circuit breaker or blown fuse, and reset or replace as needed. * Confirm that the light is switched on via the control panel.
Why does my Summit Professional VC28S turn itself on and off frequently?
If your Summit Professional Wine Cooler turns itself on and off frequently, here are some possible reasons: * The room temperature may be higher than average, so consider placing the appliance in a cooler location. * Adding a large number of bottles at once can cause this issue; allow the appliance time to reach the set temperature. * Opening the door too often or not closing it completely can also cause this; avoid unnecessary openings and ensure the door is properly closed. * Check the door seal; clean or replace it if it's not sealing properly.
What to do if the door will not close properly on my Summit Professional VC28S Wine Cooler?
If the door of your Summit Professional Wine Cooler will not close properly, check these potential causes: * Ensure the appliance is level by adjusting the feet. * If the door was reversed, make sure the door hinge is correctly reassembled. * Clean the door gasket. * Verify that the shelves are correctly positioned.
How to fix a Summit Professional VC28S that does not operate?
If your Summit Professional Wine Cooler does not operate, check the following: * Ensure the appliance is properly connected to a power supply. * Make sure the appliance is switched on. * Check for a tripped circuit breaker or a blown fuse; switch on the circuit breaker or replace the fuse if necessary.
Why does the alarm sound and the temperature display flash on my Summit Professional VC28S Wine Cooler?
If the alarm sounds and the temperature display flashes on your Summit Professional Wine Cooler, it could be due to several reasons: * The door may have been open for longer than 60 seconds; in this case, close the door. * The door might be opened too often, so try to limit how frequently you open it. * The ventilation opening could be covered or dusty; clear any obstructions and remove dust. * There may have been a lengthy interruption to the power supply; allow the appliance some time to reach the set temperature.
What to do if my Summit Professional VC28S is not cold enough?
If your Summit Professional Wine Cooler isn't getting cold enough, consider these potential causes: * The temperature may not be set correctly. Check the set temperature and adjust if needed. * The ambient temperature may require a lower temperature setting, so try setting a lower temperature. * Opening the door too often can impact the temperature. Avoid opening the door more than necessary. * Ensure the door is completely closed and properly sealed. Clean or replace the door seal if it's not hermetically sealed. * A dirty condenser can also affect cooling. Clean the condenser when necessary. * Check for any blockages or dust in the ventilation opening and clear them.
General| Model | VC28S |
|---|---|
| Type | Wine Cooler |
| Capacity | 28 bottles |
| Shelves | Wooden |
| Temperature Zones | Single Zone |
| Brand | Summit |
| Temperature Range | 41 to 64°F (5 to 18°C) |
| Finish | Stainless Steel |
| Installation | Freestanding |
| Door | Glass |
| Voltage | 115V |
To Next Page
