Sun Microsystems SUN BLADE 150 - Finishing Component Replacement

Sun Blade 150 CD-ROM, DVD-ROM, and Hard Drive Installation 13
6. Detach the wrist strap, replace the system cover, and power on the system as
described in “Finishing Component Replacement” on page 13.
Finishing Component Replacement
1. Remove the wrist strap from the system chassis and from your wrist.
2. Position the system cover onto the system chassis.
Caution – Ensure that the hard drive cables will not be damaged when you replace
the system cover.
3. Slide the system cover toward the front of the system until the cover tabs lock
(
FIGURE 9).
4. Using a No. 2 Phillips screwdriver, replace the two screws securing the system
cover to the chassis.
FIGURE 9 Replacing the System Cover