to the interface ③ and place the other end close to the battery.
CAUTION: If the remote temperature sensor is not connected to the
controller,, the default setting for battery charging or discharging
temperature is 25 °C withouttemperaturecompensation.
Connect the accessories for RS485 communication
Refer to chaper3.3 “Setting”
CAUTION: If the remote temperature sensor is not connected to the
controller,, the default setting for battery charging or discharging
temperature is 25 °C without temperaturecompensation.
Step 5：Powered on the controller
Closing the battery fuse will switch on the controller. Then check the status of the
battery indicator (the controller is operating normally when the indicator is lit in green).
Close the fuse and circuit breaker of the load and PV array. Then the system will be
operating in the preprogrammedmode.
CAUTION: If the controller is not operating properly or the battery indicator
on the controller shows an abnormality, please refer to 4.2
“Troubleshooting”.
13
To Next Page
Loading...