8
To clean the bowl & the body
1.Set the off/floss switch to the OFF position
and remove the plug from the power point.
2.Turn the bowl clockwise to remove from the
main part of the body.
NOTE: Never use abrasive cleaners or
solvents, as they may scratch the surface.
3.Wash the bowl with a soft cloth or sponge
using cold or warm soapy water.
4.Dry the bowl thoroughly before using again.
NOTE: Never immerse body in water or any
other liquid.
To clean the extractor head assembly
1.Set the off/floss switch to the OFF position
and remove the plug from the power point.
2.Allow the extractor head to cool down for
approximately 20 minutes before removing
from body.
3.Soak the extractor head assembly in hot
water before washing to loosen sugar
deposits and to make cleaning easier.
Wash the extractor head assembly with a
soft cloth or sponge in warm soapy water
and dry thoroughly. Do not use abrasive
cleaners or solvents.
Care & Cleaning
To Next Page
Loading...
