Suncast Tremont - Page 23

Shed Assembly/Doors
Stand right door ( M) upright with three hinge mounts
facing right. Slide one metal door hinge ( R) up onto each
hinge mount. Rotate door hinges to outside of door.
Secure each metal hinge plate with one screw ( A) and
one nut ( B). Repeat Steps 31-33 for left door ( L).
Note: For clarity, illustration is shown with roof and back
panel removed.
With door hinge in open position, slide one door hinge
over each hinge receptacle on inside of right front corner.
Note: For clarity, illustration is shown with roof removed.
Insert two screws ( FF), into left latch plate ( DD), and
through pre- drilled holes in doors. While holding plate in
place on exterior door, secure with two washers ( HH) and
two locking nuts ( JJ). Repeat for right latch plate ( EE).
23