Sunex Tools SX231B User Manual

SX231B: Parts Breakdown & Operating Manual 1 Rev. 05/17/10
Collet Size .....................................1/4"
Max. Free Speed ............ 25,000 RPM
Weight .......................................0.8 LB
Length .........................................5.13"
SX231B
1/4" MINI DIE
GRINDER
Average Air Consumption ....... 4 CFM
Air Inlet ................................. 1/4" NPT
Air Supply Hose Size .............3/8" I.D.
Sound Level ......................... 94.5 dBA
SPECIFICATIONS
AVOID PROLONGED EXPOSURE TO VIBRATION
RPM OF CUTTING WHEEL MUST MEET OR
EXCEED RPM OF TOOL (25,000 RPM)
WEAR HEARING PROTECTION
ALWAYS WEAR SAFETY GOGGLES
ALWAYS READ INSTRUCTIONS BEFORE
USING POWER TOOLS
Some dust created by power sanding, sawing,
grinding, drilling, and other construction
activities contains chemicals known to cause
cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
• leadfromlead-basedpaints,
• crystallinesilicafrombricksandcement
and other masonry products, and
• arsenicandchromiumfrom
chemically-treatedlumber.
Your risk from these exposures varies,
depending on how often you do this type
of work. To reduce your exposure to these
chemicals: work in a well ventilated area, and
work with approved safety equipment, such as
those dust masks that are specially designed to
filter out microscopic particles.
RPMRPMRPM
WARNING
WARNING
Operating Instructions • Warning Information • Parts Break down

Sunex Tools SX231B Specifications

General

Free Speed	20, 000 RPM
Air Inlet	1/4" NPT
Average Air Consumption	4 CFM
Collet Size	1/4"
Arbor Size	1/4"
RPM	20, 000
Power Source	Pneumatic
Weight	1.5 lbs
Type	Die Grinder
Wheel Diameter	2"

Summary

General Safety Precautions

Read and Understand Instructions

Always read and understand all information before operating the tool.

Wear Appropriate Safety Gear

Always wear safety goggles and hearing protection.

Vibration and RPM Safety

Avoid prolonged vibration exposure and ensure wheel RPM meets tool RPM.

Health Hazard Warning: Dust and Chemicals

Important Safety Warnings

Tool Operation and Maintenance Standards

Air Pressure and Hose Requirements

Eye and Hearing Protection

Air Pressure Safety Procedures

Never direct air at others, turn off supply, and drain pressure before maintenance.

Hose and Tool Handling

Clothing and Jewelry Precautions

Grinding Wheel Mounting Safety

Use correct mounting, blotters, and ensure wheels are free-fitting to prevent breakage.

Air Supply and Lubrication

Recommended Air Pressure

Air Quality and Maintenance

Daily Air Motor Lubrication

Troubleshooting and Operation

Cutting Wheel Safety

Always wear safety goggles and use wheels rated at 25,000 RPM or higher.