When initializing / when
measuring reference value
Error code “ ” appears, when the head-cover of measuring part is opened or when
the reference material(white Teflon) inside the cover is severely damaged. Make sure to
check the condition of the cover and see if it is properly closed to the instrument, and
restart booting (initialization)..
Error code “ ” appears, when measurement value deviates out of standard range
other than preset (5 ~ 25 Brix or adjustable). Make it sure if the calibration model is
suitably selected for relevant fruit, and take re-measurement.
Error code “ ” appears, when direct sun light or indoor lamps has excessively
infiltrated to the measuring part through inside/outside of object fruit. Block the direct
sun light or use it under protection of light incident..
Error code “ ” appears, when the size of object fruit is either so small or too big,
when the fruit is excessively rotten or damaged, when the surface is moist, or when the
object fruit is improperly placed on the measuring part of instrument. Check the status
of object fruit and make it sure the fruit is properly placed on the measurement part of
the instrument.
When error code “ ” appears, the instrument can still be used to take
measurement, but need to contact A/S center.
When error code “ ” appears, the instrument can not be used. Need to
contact A/S center immediately.
For abnormalities or malfunctioning other than the above descriptions, do not take countermeasures
at your discretion, but contact A/S center or service representative nearby your premises to get
technical support.
To Next Page
Loading...
