What to do if Sunforest Measuring Instruments show incorrect Brix measurement?
If the Brix measurement value deviates from the standard range (5 ~ 25 Brix or adjustable) when using Sunforest Measuring Instruments, ensure that the calibration model is suitably selected for the relevant fruit and then re-measure.
Why Sunforest H-100C fail during initialization or reference value measurement?
If you experience issues when initializing or measuring the reference value on your Sunforest Measuring Instruments, ensure that the head-cover of the measuring part is properly closed and that the reference material (white Teflon) inside the cover is not severely damaged. Then, restart the booting (initialization).
How to troubleshoot Sunforest H-100C Measuring Instruments when power doesn't turn on?
If your Sunforest Measuring Instruments do not turn on, charge the instrument for more than 30 minutes and then try to turn it on again.
How to prevent light interference when measuring Brix with Sunforest H-100C Measuring Instruments?
If you are getting errors while measuring Brix with Sunforest Measuring Instruments, and direct sunlight or indoor lamps are excessively infiltrating the measuring part, block the direct sunlight or use the instrument under protection from light incidence.
What to do if there is charging abnormality with Sunforest Measuring Instruments?
If you notice an abnormality during charging of your Sunforest Measuring Instruments, check if the charger’s plug connected to the charging terminal is properly inserted.
Why are Sunforest H-100C Measuring Instruments affected by temperature?
The spectrometer sensor built in the Sunforest Measuring Instruments is influenced by temperature. Use the instrument within standard temperature range for accuracy assurance.
What to do if Sunforest Measuring Instruments fail during initialization or measurement due to low battery?
If you face issues during initialization, reference value measurement, or Brix measurement with Sunforest Measuring Instruments, immediately charge the battery, as the problem may be due to lack of battery power.
What causes errors in Brix measurement with Sunforest Measuring Instruments?
When measuring Brix with Sunforest Measuring Instruments, ensure that the object fruit is properly placed on the measurement part of the instrument. Check the status of the object fruit to make sure the size of object fruit is neither so small or too big, or the fruit is not excessively rotten or damaged, or the surface is not moist.
What does it mean if Sunforest H-100C fail during initializing?
The instrument can not be used. Need to contact A/S center immediately.
Instructions on how to charge the instrument's internal battery for optimal performance and longevity.
Step-by-step guide on how to perform measurements on fruit samples.
Guide to configuring instrument settings like deviation and calibration models.
Techniques for correctly positioning fruit for accurate sensor readings.
General| Brand | Sunforest |
|---|---|
| Model | H-100C |
| Category | Measuring Instruments |
| Language | English |
To Next Page
