Need help?Do you have a question about the SUNFRE S10 and is the answer not in the manual?
General| Brand | SUNFRE |
|---|---|
| Model | S10 |
| Category | Automatic Barriers |
| Language | English |
How to use DIP switches for selecting input voltage (220V/110V) to output 24V DC or 12V DC.
Describes the connection of the 24V DC brushless/servo motor to the control board.
Explains the power supply outputs for the motor and control unit.
Instructions for loosening screws and rotating the arm to the mechanical limit for horizontal alignment.
How to adjust the vertical position using menu settings (DP10) after horizontal alignment.
Troubleshooting steps for when the barrier does not respond to UP/DOWN commands.
Steps to diagnose why the barrier closes partially during the power-on self-test.
Defines the working mode between continuous testing and normal operation.
Allows setting the auto-close delay time after the boom is opened.
Configuration for the RS485 communication address.
Sets the communication address for RS485 devices.
Controls the maximum opening speed of the barrier arm.
Adjusts the speed control during opening to the close position.
Sets the angle at which braking initiates during the opening sequence.
Adjusts the maximum force applied during braking while opening.
Controls the maximum closing speed of the barrier arm.
Adjusts the speed control during closing to the close position.
Adjusts the maximum force applied during braking while closing.
Sets the desired opening angle for the barrier arm.
Defines the final, slower speed as the arm reaches its open or close position.
Sets the initial opening speed and maximum auto-reverse speed.
To Next Page