Sungrow SH10RT Manual

GD_202201_Sungrow SBR HV Battery Parallel Extension Manual_V1.1 Page 1 of 18
© Sungrow Australia Group Pty. Ltd. All rights reserved.
As we continuously improving our services, changes to this document may occur without notice.
SUNGROW SBR HV Battery Parallel Extension
Manual
Disclaimer
The material in this document has been prepared by Sungrow Australia Group Pty. Ltd. ABN 76 168
258 679 and is intended as a guideline to assist solar installers for troubleshooting. It is not a statement
or advice on any of the Electrical or Solar Industry standards or guidelines. Please observe all OH&S
regulations when working on Sungrow equipment.
Scope
This Manual describes the requirements and installation procedures for SBR battery
parallel configuration.
Note: Maximum 4 batteries can be connected in parallel to compatible inverters.
1.1 Requirement
Hybrid inverter model: SH10RT
Wifi dongle: WiNet
SUNGROW SBR battery combiner box

Sungrow SH10RT Specifications

General

Model	SH10RT
Category	Inverter
Rated Power	10 kW
Max. DC Input Voltage	1100 V
AC Output Voltage	230 V
Max. Efficiency	98.4%
IP Rating	IP65
Max. DC Input Power	15 kW
Start Voltage	180 V
Number of MPPTs	2
Max. Output Current	16 A
Rated Grid Frequency	50/60 Hz
THDi	<3%
European Efficiency	98%
Max. Charging/Discharging Power	10 kW
Max. Charging/Discharging Current	25 A
Operating Temperature Range	-25°C to +60°C
Cooling Method	Natural Convection
AC Voltage Range	180 V - 280 V
Power Factor	0.8 leading to 0.8 lagging