sunjoe SPX7000E - Winterizing and Maintenance; Winterizing + Long-term Storage; Clean the Adapter Filter and Nozzle; Clean and Change the Dust Filter

mCAUTION! The use of a pump protector is
recommended to prevent cold weather damage during storage
over the winter months.
Winterizing + long-term storage
If you must store your pressure washer + wet/dry vacuum in a
location where the temperature falls below 32ºF (0ºC), you can
minimize the chance of damage to your machine by utilizing
the following procedure:
• Disconnect all water connections.
• Turn on the machine as pressure washer for a few
seconds until the remaining water in the pump exits. Turn
o immediately.
• Do not allow the high-pressure hose to become kinked.
• Store the machine and accessories in a room that does
not reach freezing temperatures.
• Do not store near a furnace or other sources of heat that
may dry out the pump seals.
• Operate the pressure washer with non-corrosive/non-toxic
anti-freeze, a pump saver, or a pump protector before
storing for the winter.
mWARNING! Before reusing, completely ush the unit
out with clear water. Anti-freeze products can damage
paintwork, so you must ensure there is no anti-freeze left in the
system before using it again.
Maintenance
mCAUTION! Before working on the pressure washer +
wet/dry vacuum, disconnect the plug from the power supply
socket.
Clean the Adapter Filter and the Nozzle
1. To ensure good performance, check and clean the adapter
lter (Fig. 26). Remove the lter and rinse with warm water
to prevent any foreign matter from clogging the pump (Fig.
27).
2. Clean the nozzle with the needle clean-out tool provided
(Fig. 28). Remove the spray wand from the gun; remove
any dirt from the nozzle hole and rinse.
Clean and Change the Dust Filter
mWARNING! Use only original manufacturer’s
replacement parts, accessories and attachments. Failure to do
so can cause possible injury and poor performance.
To order genuine replacement parts or accessories for the
Sun Joe
®
SPX7000E electric pressure washer + wet/dry
vacuum, please visit snowjoe.com or contact the Snow Joe
®
+
Sun Joe
®
customer service center at 1-866-SNOWJOE
(1-866-766-9563).
1. Remove the dust tank from the unit, and seperate the dust
bin and dust tank cap with lter (Figs. 24 – 25).
2. Grab the lter handle on the bottom, screw clockwise to
remove the dust tank cap from the old lter assembly (Fig.
29).
Fig. 26
Adapterlter Garden hose adaptor
Fig. 27
Filter
Fig. 28
Needle clean-out tool
14