7
INSTALLATION
7
ASSEMBLY INSTRUCTIONS
The Solo System has been designed for easy assembly. It can be set up and ready to use in
minutes and easily disassembled & stowed away when not in use.
The Solo System should be set up and used on the oor. Locate a oor location that affords a
degree of privacy as infrared is best received on bare skin. If you prefer to use on an elevated
surface, only use a surface that can support the weight of yourself and the weight of the Solo
System (35 kg) such as a massage table or bed. Sunlighten is not responsible for damage
to surfaces cause by the weight of the unit.
1. Open the box and remove all contents. Identify each component of the Solo.
2. Read each and every page of this manual. It is especially important that the Health
& Safety Statements be read and fully understood. The Solo System performs the
same whether used in your home or in a professional medical facility. Please check
with your personal physician if you don’t understand something in the medical precautions.
3. Verify that an electrical outlet of proper voltage (varies by country) is available at
the location to be used. Position the Solopad (if purchased).
4. Place a tted Solopad Bamboo Carbon cover (sold separately) over the entire length
of the Solopad. Alternatively you may use a towel and lay it out smoothly over
the length of the pad.
5. Place the pillow, if purchased, into position at the top of the Solopad.
6. Place the two Solo domes at the bottom of the Solopad, positioned so that
the open ends face the top.
7. Connect the two cords from the Solo controller to the domes. One to the upper
dome; one to the lower dome.
8. Plug the Solo controller into the electrical outlet (check for proper voltage and
grounding by referencing the specs on page 5).
9. Turn on and set the Solo controller to its lowest setting. This can be adjusted when you
are ready to use the Solo. Next set time to the session length desired. NOTE: each dome
has a separate adjustment. Domes adjust in whole number increments.
10. Verify that the blue LED’s on the controller are lit.
11. Place the control box in a position as to be easily reached from your right arm when
using the Solo.
12. Use the supplied Bamboo Carbon Curtain to drape over the opening of the Solo upper dome.
This is necessary to retain heat.
13. Setup is complete. You are now ready to enjoy the Solo System.
To Next Page
Loading...
Need help?
General
