9
OPERATING INSTRUCTIONS
Position your head on the pillow so that you are comfortable. The pillow should be
positioned outside of the Solo domes and we recommned you cover it with a towel to
absorb the sweat. Close the drop curtain to retain the heat within the Solo. It is now time
to relax and enjoy the soothing heat of the Solo. Do not have your head inside the Solo
for prolonged periods. Remove immediately if feeling faint or dizzy. When the session is
over, the Solo heater output will stop. Push back the upper dome and exit the Solo.
Turn off the controller.
The Solo System will cause you to sweat profusely. Taking a shower after each session
will remove the perspiration from your skin and add to the cleansing feeling that is felt
when using the Solo. Dry with a fresh clean towel if no showering facilities are available.
At the end of use, remove all towels from inside the Solo. Fully extend the domes and
let them cool down. Do not collapse the two domes until after they are completely cool.
After use unplug, then wipe down the Solopad and pillow using a slightly damp cloth
that has been immersed in a mixture of Tri-Nature Stain Removal and warm soapy water.
Be sure not to get the control box or power cords wet during cleaning. Always keep the
Solopad covered with a tted Bamboo Carbon cover during use to keep it clean.
Fresh towels should be used when enjoying your sessions in the Solo. Bamboo Carbon
towels can be purchased at
https://shop.sunlighten.com.au/collections/bamboo-carbon-towels
*
The number above UPPER is the level set for the upper dome,
while the number above LOWER is the level set for the lower dome.
solo
upper
POWER ON/OFF
TIMER DISPLAY
TIMER CONTROLLEVEL CONTROL
LEVEL DISPLAY
*
CHROMO
REMOTE SENSOR
To Next Page
Loading...
Need help?
General
