Air Deflector Installation
Sunlover offers Air Deflectors as an optional purchase.
Recirculating the front air discharge back into the heat
pump's air intake should be avoided.
If there are space constraints, installing an Air Deflector
is a straightforward and economical solution.
NO PRE-DRILLING REQUIRED
Items required:
• Air Deflector/s
• Mounting hardware
4x 15 - 20mm long self tapping screws or tek
(metal cutting) screws per deflector
the screws should preferably be gal or stainless steel for long
term outdoor use
• Determine the appropriate placement. Ideally, the air
deflector should be installed perpendicular to direct air
upwards. However, a deflector can also be installed to
redirect air discharge to the side( see below example)
• Place the deflector level over the fan cage, positioning
with the large depth open end facing the direction
where the air is to be expelled, making sure that the
cage is completely enclosed and the deflector is level.
• The deflector is equipped with installation tabs on both
sides, each featuring three holes as illustrated above.
Once you have determined the best placement for the
screws, mark the location of the chosen holes on the
tabs using a marker for reference.
• Proceed to attach the deflector to the front of the heat
pump using long self-tapping or tek screws to secure,
taking care not to over-tighten the screws. This will
ensure that the deflector remains firmly in place and
directs the air flow as desired.
To Next Page
