18
5. If changed successfully. There will pop up a response window
(see the right picture). You also can print a self-test page to
check again. (The current IP on the self-test page should be
updated to 192.168.1.205). And then, you perhaps need to
reset the computer IP to 192.168.1.XXX. (XXX must be a
number between 0 to 255, not including 0 and 255, and
must not be the same as any other IP address in the LAN).
6. Connect the printers and computers to LAN, check if working normally. See the following picture:
To Next Page
Loading...