Installation
975-0294-01-01 3
Installation
The SunPower Solar Monitor can be mounted two ways:
• Flush mounted through an opening in a wall using the
supplied mounting plate.
• Surface mounted using the supplied mounting bracket.
The monitor connects to the inverter with a network cable
that is plugged into one of the monitor’s network ports (see
Figure 2). The other network port on the monitor must be
terminated with a network terminator.
Because you cannot access the network ports when the unit is
mounted, the network cable needs to be routed from the
inverter and through the wall before you secure the monitor.
Figure 2
SunPower Solar Monitor Rear View
WARNING: Shock hazard
For installation by qualified installers or electricians only.
Network
ports
SunPower-Wired-Remote.book Page 3 Friday, July 7, 2006 5:09 PM
To Next Page
Loading...
