Installation
975-0294-01-01 7
Flush Mounting
To mount the monitor:
1. Using a jigsaw and the supplied template sticker as a
guide, cut out the hole for the mounting plate. The
mounting plate fastens to walls up to ¾ inch (19 mm)
thick.
2. Route the network cable from the inverter inside the wall
and through the opening.
3. Insert the mounting plate with the two tabs in a vertical
position into the hole (see Figure 5).
CAUTION: Unpredictable device behavior
Do not connect one end of the network to the other to make a ring
or loop.
CAUTION: Equipment damage
Connect the monitor only to a SunPower Solar Inverter (models
SPR-3300x-208, SPR-3300x, SPR-4000x).
Although the cabling and connectors used in this network system
are the same as Ethernet connectors, this network is not an
Ethernet system. Equipment damage may result from attempting
to connect these two different systems.
SunPower-Wired-Remote.book Page 7 Friday, July 7, 2006 5:09 PM
To Next Page
Loading...
