4
Add a Wireless Wind Sensor
Figure 1
Figure 2
Figure 3
Figure 3
The LED on the Sensor Body will blink.
Step 3
Note: The Awning Motor will not accept a command
Wireless Wind Sensor has retracted the Awning.
Step 6
To shake the Front Bar,
the Bar to drop freely. Repeat quickly.
Steps 1 to 6
NEW SET OF BATTERIES
800-670-7071
WARNING: YOU MUST BE CERTAIN THAT THE WIRELESS
WIND SENSOR IS INSTALLED, PROGRAMMED AND
OPERATING PROPERLY.
FAILURE TO DO SO MAY RESULT IN THE WIRELESS WIND
SENSOR NOT BEING ABLE TO CLOSE YOUR AWNING
DURING WINDY CONDITIONS, WHICH COULD CAUSE
DAMAGE AND PERSONAL INJURY. IF THE MOTOR
DIRECTION IS REVERSED THE SENSOR WILL EXTEND
(OPEN) THE AWNING IN WINDY CONDITIONS, INSTEAD
OF CLOSING IT.
Add a Wireless Wall Switch
Figure 1
Figure 2
Figure 1
Rear
Programming
recessed
inside this
small opening
Remote Transmitter
Figure 2
Channel
Indicator
Lights
Channel
Selector
Programming
recessed inside
this small
opening
Multi-Channel Wall Switch
Figure 2
Figure 3
THEN
FIRST
Figure 1
LEFT
Lateral_SuneaMotor_Repl-v2
January 12, 2015
To Previous Page
Loading...