9
25.
Figure 9
Note: If the Motor will not easily slide into the Roller
Bar, you may have selected the wrong slot.
Note: Make sure that the dark Gray Bushing is sll
on the Round Pin end of the Roller Cap on the end of
the Roller Bar opposite the Motor. See Figure 10.
26.
See Figure 10
27.
See Figure 7
See Figure 11
28.
Figure 8
29. Align the holes in the Corner Braces and
30.
WARNING: THE FOLLOWING PROCEDURE SHOULD BE
ACCOMPLISHED BY FOUR (4) PEOPLE.
31.
each Leg Assembly
the OASIS is placed in
See Figure 12
Figure 9
Slot
MOTOR
Figure 10
Figure 11
Figure 12
To Next Page
Loading...
