Sunso WTP-800 - 4.3 Power Connection

WTP-800 User Manual
16
4.3 Power Connection
1) Put the cable plug of power adapter facing up at flat side, insert the rear of the printer power
connector;
2) Turn the power adapter input power;
3) Pay attention about disconnecting or connect the Power adapter at right method, or likely to
cause damage.
Note: The Power adapter and power cord vary by local and region.
When pull out the adapter, please pinch the shell of power adapter and pull the switch up, when
the switch is fully opened then pull out the power adapter.
Don’t put forth your strength to pull the plug by squeeze at any of place of power adapter. Because,
it is more difficult to pull it out and easy to damage the cable.