SunStar SPS/A-Pattern Series - Page 111

111
C. Move to “ ” by using
keys and press key.
ENTER
direction
16.Output4 Test
D. Repeat turning on and off relevant air pressure port
by pressing the number of air pressure port to be
tested.
1. : Rear Clamp
2. : Thread Release device
3. : material conveying pressing device
4. : Thread Release device 3
5. : Head of machine
6. : Laser Point
7. : not in use
8. : not in use
AX7
AX6
LPT
HEAD
TRS3
AFC
TRS
RFF
1 RFF Of 2TRS Of
3 AFC Of 4TRS3 Of
5 HEAD Of 6LPT Of
7 AX6 Of 8AX7 Of
18.Output6 Test
19.Output7 Test
20.DAC0
21.DAC1
E. Press key to end air pressure port test. Press key to end Test Menu.
ESCESC
F. Press key to return to initial page.
ESC
1-18) Output5 Test [Only applied for SPS/C-Series]
This is used to check whether or not air pressure device related to SPS/C-Series is working properly.
<< Main Menu >>
4. Machine Test
5. Pattern List
6. EMB Call
A. Press key.
MODE
<< Test Menu >>
17.Output5 Test
18.Output6 Test
19.Output7 Test
B. Move to “4 Machine Test” by using
keys and press key.
ENTER
direction
1-19) Other Output Ports [Only applied for SPS/C-Series]
Following output port tests are not in use.