189
Connector and jumper pin position
Connector position on the rear side of the
PC box
Connector and jumper pin positions on the I/O board
Connector for sensor signal input
Connector for signal input [CN16]
Jumper pin for changing sensor input
power supply
Connecting the auto call function cable
(connector: 1625-15Plug)
Connecting the auto call function cable (connector: XHP-9)
No. Description
Remarks
Changing jumper for sensor input power change
▶ The input power supply to the sensor can be altered to +5V / +24V by changing the BR jumper at the upper left side
of the I/O board.
The auto call function uses the adjacent sensor. Therefore connect the jumper pin to No. 2 and No. 3.
(Jumper pins for change: BR6, BR7, BR8 )
When changing the sensor specifications depending on the user needs, change the input power supply.
Caution
To Next Page
Loading...
