37
ORIGIN
X:00000A N:00000
Y:00000A
Function Code?
014:PTRN READ
NO :001
CIRCLE
X:-0067A N:00052
Y:-0092A
Function Code?
TRIM
X:-0220A N:00029
Y:00040A
Function Code?
C. After moving to “2. Program” menu by using
direction key press ENTER key. At this
time, the upper feed plate comes down and
moves to the original point.
D. After pressing READ key, input the pattern
number to delete partial pattern by using digit
key and read in the pattern by pressing
ENTER key. (For example, input [0][0][1] to
read the pattern number 001).
E. Go to the pattern that the shape to delete
exists by using FORW and BACK key.
※ X-Y coordinate value is different according
to needle location.
F. Delete is available by two methods as below.
- After pressing CODE key, input Function code
039 and press ENTER key.
- Or press PTN. DEL key of OP.
G. Press PTN.DEL key on operation box (OP).
Reference) After deleting as much as the number of
defined stitches, if end point and start point of two
sewing data existing at both sides do not match and
have distances, a jump is automatically made between
the two sewing data. If you want to input automatic
thread trimming, you can set up at “057:AUTO TRM”.
H. Confirm if desired partial pattern shape was
deleted by using FORW and BACK key. (Line
is deleted by once.)
I. Delete the partial pattern data to delete
repeatedly in the order of E-F-G.
To Next Page
Loading...
