SunStar SPS/A-Pattern Series - Page 38

38
2-5) Partial Stitch Width Changing Function
Change stitch width by selecting a fixed part from the pattern shape.
End Point of Stitch
Width Change
Start Point of Stitch
Width Change
End Point of Stitch
Width Change
Start Point of Stitch
width Change
Current Stitch Width 3.0mm
Current Stitch Width 2.0mm
< Before Partial Stitch Width Change > < After Partial Stitch Width Change >
ORIGIN
X:00000A N:00000
Y:00000A
Function Code?
014:PTRN READ
NO :001
A. Insert USB flash drive containing the pattern to
change stitch width.
B. Press MODE key.
C. After moving to “2. Program” menu by using
direction key , press ENTER key. At this
time, the upper feed plate comes to descend.
D. After pressing READ key, input the pattern
number to change stitch width by using digit
key and read in the pattern by pressing
ENTER key. (For example, input [0][0][1] to
read the pattern number 001.)
LINE
X:-0070A N:00021
Y:00140A
Function Code?
E. Go to the location to start change of stitch
width by using FORW and BACK key.
※ X-Y coordinate value is different according
to needle location.