39
<Function Code>
013:STI WIDT<
014:PTRN READ
015:PTRN WRITE
013:STI READ
WIDTH:020[0.1mm]
<RANGE SETTING>
X:00142A N:00029
Y:00089A
F. After pressing CODE key, if you know the
function number related to pattern programming,
input three-figure digit number 013, and if you
do not know, press ENTER key. Then after
moving to “013:STI WIDT”by using direction key
, press ENTER key.
G. Input the stitch width value to change and
press ENTER key.
H. Move to the location to complete stitch width
change by using FORW and BACK key.
ARC
X:00133A N:00052
Y:00061A
Function Code?
I. If you press EXE key, change of stitch width is
completed.
※ X-Y coordinate values are different
according to current location.
J. Confirm if change of stitch width was made
properly by using FORW and BACK key.
2-6) Pattern Partial Copy Function
Set a fixed part of pattern shape and copy to desired location.
Copy End Point
Copy Start Point
Scope to Copy
Location to Copy
To Next Page
Loading...
