40
ORIGIN
X:00000A N:00000
Y:00000A
Function Code?
014:PTRN READ
NO :001
A. Insert USB flash drive containing partial pattern
to make partial copy.
B. Press MODE key.
C. After moving to “2. Program” menu by using
direction key , press ENTER key. At this
time, the upper feed plate comes down and
moves to the original point.
D. After pressing READ key, input the pattern
number to copy partial pattern by using digit
key and read in the pattern by pressing
ENTER key. (For example, input [0][0][1] to
read the pattern number 001.)
JUMP
X:00174A N:00070
Y:00183A
Function Code?
<Function Code>
047:COPY PTRN<
048:DEL PTRN
049:REV SET
E. Go to copy start location by using FORW and
BACK key.
F. After pressing CODE key, if you know the
function number related to pattern programming,
input three-figure digit number 047, and if you
do not know the number, press ENTER ey.
Then, after moving to “047:COPY PTRN” by
using direction key , press ENTER key.
<RANGE SETTING>
X:00174A N:00088
Y:00183A
G. Go to the copy completing location of pattern
by using FORW key.
※ X-Y coordinate values are different
according to current location.
047:COPY PTRN
X:00174
Y:00183
N:000
H. If you press EXE key, it becomes the state to
move to the location to copy.
Reference) Location of the needle for partial copy should be
placed at the first start needle location that actually sews.
Therefore, if the sewing data that has line property next
jump appears, the last location of JUMP data is the first
start location of needle correction.
To Next Page
Loading...
