41
047:COPY PTRN
X:00174
Y:-0133
N:000
I. Move to the location to copy by pressing direction
key.
※ The indicated values are different according
to current location.
LINE
X:00174A N:00088
Y:00183A
Function Code?
J. If you press EXE key, copy is completed.
K. Confirm if copy was made properly by using
FORW and BACK key.
2-7) Pattern Data Inserting Function
It is the function made that pattern data inserting is available because the behind data is protected
though new pattern data is added in the middle of pattern data.
Inserting Point
Pattern Data
End Point
Pattern Data
Start Point
< After Pattern Data Insertion >
ORIGIN
X:00000A N:00000
Y:00000A
Function Code?
A. Insert USB flash drive containing the pattern to
insert.
B. Press MODE key.
C. After moving to “2. Program” menu by using
direction key , press ENTER key. At this
time, the upper feed plate comes down and
moves to the original point.
Inserting Point
Pattern Data
End Point
Pattern Data
Start Point
< Before Pattern Data Insertion >
To Next Page
Loading...
