67
<Function Code>
040:BACK TACK<
041:CNDNS STI
042:OVLAP STI
F. After pressing CODE key, if you know the
function number related to pattern programming,
input three-figure digit number 040 and if you
do not know the number, press ENTER key.
Then, after moving to “040:BACK TACK” by
using direction key , press ENTER key.
040:BACK TACK
BTNUM:4[STITCH]
G. Input the number of back tack to insert and
press ENTER key.
040:BACK TACK
BTNUM:4[STITCH]
BTMOD:0[0/1]
H. Input back tack mode. Press ENTE key.
Mode Type
Mode 0:
Mode 1:
LINE
X:-0160A N:00040
Y:00039A
Function Code?
I. Confirm if back tack was made properly by
using FORW and BACK key.
3-12) OverLap Sewing Stitch Inserting Function
You can apply automatic overlap sewing stitch inserting function for several patterns.
OverLap function can apply to the pattern design of closed roof that start point and end point meet.
Except, though it is not closed roof type of pattern and start point and end point have 1mm of distance,
OverLap function can use.
Be able to select a maximum of 20 stitch.
5 Stitch OverLap
5 Stitch OverLap
Origin Point of Machine
To Next Page
Loading...
