68
A. Insert USB flash drive containing the pattern to
insert overlap sewing stitch.
B. Press MODE key.
C. After moving to “2. Program” menu by using
direction key , press ENTER key. At this
time, the upper feed plate comes down and
moves to the original point.
ORIGIN
X:00000A N:00000
Y:00000A
Function Code?
014:PTRN READ
NO :001
D. After pressing READ key, input the pattern
number to insert overlap sewing stitch by using
digit key and read in the pattern by pressing
ENTER key. (For example, input [0][0][1] to
read the pattern number 001.)
CIRCLE
X:00000A N:00030
Y:00100A
Function Code?
E. Go to the location that pattern data ends in
order to apply overlap function by using FORW
and BACK key.
<Function Code>
042:OVLAP STI<
043:SYMMETRY X
044:SYMMETRY Y
F. After pressing CODE key, if you know the
function number related to pattern programming,
input three-figure digit number 042 and if you
do not know the number, press ENTER key.
Then, after moving to “042:OVLAP STI” by
using direction key , press ENTER key.
042:OVLAP STI
OVNUM:4[STITCH]
G. Input the number of overlap stitch to insert and
press ENTER key.
CIRCLE
X:-0092A N:00034
Y:00037A
Function Code?
H. Confirm if back tack was made properly by
using FORW and BACK key.
To Next Page
Loading...
