SunStar SPS/A-Pattern Series - Page 87

87
J. Return to the initial screen. To create ,
input switch width by using Line key.
Second Line
I. When is pressed, the following screen
appears. Move the cursor to ON and press
. Upon striking ,
code is created at
.
the line
the end of line adjuster
the 3rd
ENTERENTER
ENTER
063:SET TR3
TR3 :OFF
ON <
TR3 ON NONE
X:00650A N:00105
Y:00300A
Function Code?
K. Press key and then resister
by using key.
The feed plate moves to the set position in
accordance with the data calculation result.
EXE
Second Line
PNT.SET
LINE NONE
X:00650A N:00125
Y:-0300A
Function Code?
L. To program , press key. Function is
63. The concerned function code is 063. If you
want to search it from the function code list,
press and move to
with direction keys .
063 SET TR3
ENTER
CODETR3
<Function Code>
063:SET TR3 <
063:SET TR3
TR3:OFF <
ON
M. When is pressed, the following screen
appears. To cancel the setting, move the
cursor to and press . At the
same time, the is
programmed at the end of the created Line.
thread control device 3
ENTEROFF
TR3
ENTER
TR3 OFF NONE
X:00650A N:00126
Y:-0300A
Function Code?
N. Return to the initial screen.
P. If there is no problem with sewing, press key again, and then press key to save design.
WRITE
TEST
O. Create third and as the way the first and second lines are created. And then press TEST to check
whether is operating or not.
in the . TR3 will be at at the beginning of the and OFF
at the .
end of the second LINE
second LINEONfirst LINETR3 is set at OFF
TR3
fourth line