88
3-26) Basic Clamp Position Setting
※This function is to set the basic position of the clamp. When parameters need to be changed, clamp’s
pneumatic lines shall be exchanged in accordance with conditions.
A and B
<< Main Menu >>
1. Parameter Set <-
2. Program
3. Bobbin Wind
A. Select .
Parameter Set
104 : Clmp Ref POS
1)Ref_UP
<-
2)Ref_DOWN
B. To change the basic position of the clamp to
, go to Parameter and
select .
(Default is .)
1) Ref_UP
2)Ref_DOWN
104. Clmp Ref POS
Down
※ Key Points
1. If the value of is changed to , the two pneumatic tubes connected to the
clamp shall be exchanged.
Ref_DOWN104.Clmp Ref POS
To Next Page
Loading...
