SunStar SPS/A-Pattern Series - Page 93

93
A. Press MODE key.
B. Move to “1. Parameter Set” by using direction
keys .
C. When you press ENTER key, you can get
the screen like a figure on the right side. If you
know the parameter number related to general
sewing, input the three digit parameter number.
For example, if you want to change “004:Strt
Ret Mod”, input [0][0][4]. At this time, you
should input [0] twice for the first and second
digits.
※ Appendix :
Refer “Parameter number related to general sewing.”
D. If you don’t know any relevant number, press
ENTER key to move to the parameter
number you want by using direction keys .
※ Appendix :
Refer “Parameter number related to general sewing.”
<< Main Menu >>
1. Parameter Set
2. Program
3. Bobbin Wind
<Parameter Set>
PARA No : 004
<Parameter Set>
004.Strt Ret Mod
005.Bobbin Count
006.Prodct Count
4-5) Change of Parameter Related to General Sewing
It is used when you want to change the working condition of electrically controlled pattern sewing machine
to be best for working efficiency and user’s need.
E. After pressing ENTER key, change the setting
value or any state you want by using direction
keys .
004:Strt Ret Mod
1) SHORTEST <-
2) ORG_TO_STR
3) REV_ORG_STR
G.
If you want to back to the previous menu, press
ESC key.
H. Press ESC key to back to the initial screen.
※ You can confirm the machine backs to the sewing
start point directly without passing through the
origin after finishing sewing.
<< Main Menu >>
1. Parameter Set
2. Program
3. Bobbin Wind
F. If you press ENTER , the changed condition
will be valid and the machine backs to the
previous menu. If you don’t want any change,
press ESC to cancel it.
<Parameter Set>
004.Strt Ret Mod
005.Bobbin Count
006.Prodct Count