SunStar SPS/A-Pattern Series - Page 94

94
A. Press MODE key.
B. Press ENTER key.
C. After moving to “1. Para. Init.”menu by using
direction keys , press ENTER key. Then
you can see the screen like a figure on the
right side. When a parameter initialization is
finished, previous screen appears.
<< Main Menu >>
0. Initialize
1. Parameter Set
2. Program
<< Initialize >>
1. Para. Init.
2. Sys. UpDate
System Parameter
Initializing....
4-6) Initialization of Parameter Related to General Sewing
It is used for parameter related to general sewing to back to the factory-installed setting value. It is
recommendable that only professional A/S engineer handles it.
D. Press ESC key to back to the general sewing
mode.
NO:000 NOR_SEW
XS:100%
YS:100% SP:1500
BC:000 PC:0000